User Guide

5-axis MachiningSolidCAM2005 Milling Manual
112
9.3.2 Tool axis will be tilted relative to cutting direction
This option enables you to change the lag angle of the cutting direction
as well as the lag angle at the side of the cutting direction. Both are
shown below.
Simulate the appropriate Operation of
Exercise9 The CAM-Part is located in the
Exercises\Tilting_strategies folder.
The tool axis is tilted only with a lag angle of
45° to the cutting direction and 0° at the side
of the cutting direction.
Cutting direction
Tool Axis
Surface Normal
45°