Users Manual

APP
Main screen to appear when it is executed
Main screen to appear when a model is
selected.
Select a desired model You can find a model by aligning on
required conditions
Select a mco device
Save Motion
(start saving à operate à stop saving )
Replay Motion
(If there is motion saved, it changes green and if a button is pressed, replay starts)
Communication is cut off
Operation Mode
Mode 1
Mode 2 - One control unit runs two motors
(It can switch direction and drive the front and
rear of automobile model with steering wheels
at the same time)
Mode 3 - Control mode using a gyro sensor
mco connection
Servo motor connector
-upper : servo motor 1
-lower : servo motor 2
*The visible part of the metal
pin upwards
Deceleration motor
1, 2 connector
Battery 1, 2
connector
Each connector
protrusion is
positioned at the top
Switch