User's Manual
Table Of Contents
- Section1 Safety & Certification Notice
- Section2 System configuration and Functions
- 2.1 HROU (High power Remote Optic Unit)
- 2.1.1 Specifications of HROU
- 2.1.2 Block Diagram of HROU
- 2.1.2.1 HMRU block diagram
- 2.1.2.2 ROU inner look
- 2.1.2.3 HROU part list
- 2.1.3 Function by unit
- 2.1.3.1 High Remote Drive Unit (HRDU)
- 2.1.3.2 Remote Power Supply Unit ( RPSU)
- 2.1.3.3 Remote Optic(ROPTIC)
- 2.1.3.4 Remote Central Processor Unit (RCPU)
- 2.1.3.5 Multiplexer
- 2.1.3.6 System interface unit (SIU)
- 2.1.4 Bottom of HROU
- 2.1.4.1 Functions
- 2.1 HROU (High power Remote Optic Unit)
- Section3 System Installation
Confidential & Proprietary 35/48
CU4-
L7085IC19P21A25T
DL
Multiplexer3
The integrated CU that combines all band for output
to a single antenna output. Either 700LTE or 850IC
band is combined to
the single antenna output
through the designated port for dual input prepared
at upper right corner.
1EA,
optional
CU7-23W25TDL
Multiplexer4
This integrated CU combines two bands for output to
a single antenna connection.
1EA,
optional
No combiner
If no combiner is used, all amplifier outputs should be
connected directly to the individual antenna
connectors on the bottom of the enclosure
1EA
Power Cable1 MS Connector with 4 hole(AC and DC) 1EA, HMRU
Power Cable2
MS connector for HMRU connection with MS con and
Circular connector on the each side of end
1EA, HARU
HMRU HRDU Max 4RDUs in the one enclosure Max 4EA
Basically, the common part of HROU should have an enclosure and it is equipped with RCPU to inquire
and control state of each module, R_OPTIC to make both of electronic-optical and optical-electronic
conversions, RPSU to supply power for HROU. It should have Power Cable for external rectifier or to supply
required power.
In addition, HRDU can be mounted and removed to provide service for desired band.