Installation and Operation Manual

Confidential & Proprietary 38/57 Alliance-TR
The required part number is JOCT 16-6 supporting AWG #6. When installing ground terminal, refer to the
figure below.
Figure 5.7 – Ground Terminal Installation
The procedures are;
1. Loosen two M6 screws and then remove the compression terminal from the enclosure.
2. Insert AWG #6 grounding wire into the terminal and then crimp the terminal around it.
3. Re-connect the terminal to the enclosure.
4. Cut the ground wire to the proper length and connect to the communication GND of the building.