User's Manual

Confidential & Proprietary 43/44
Theproceduresare
1. LifttheHRDUontotheguidebracketandensuretheMRDUislevellefttoright
2. PushtheHRDUintothecorrespondingslotinthedirectionoftheheatsinkwhilelevellingthe
MRDUtoguidebracket
3. MakesuretheHRDUisfirmlyinsertedinto
thecorrespondingslot.Tightenthe4cornerscrews
tosecuretheunit
4. InstallHRDUblankcardsin allunusedslotsintheremote.Firstinserttheblankcardintothe
correspondingslot,thentightenthecaptivescrewtosecureit
"TheManufacturer's rated outputpowerof this equipmentisfor single carrieroperation.For
situationswhenmultiplecarriersignalsarepresent,theratingwouldhavetobereducedby3.5
dB, especially where the output signal is re‐radiated and can cause interference to adjacent
bandusers.Thispowerreduction
isto bebymeansof input powerorgainreductionandnot
byanattenuatorattheoutputofthedevice."

RSS‐GEN,Sec.7.1.2–(transmitters)

UnderIndustryCanadaregulations,thisradiotransmittermayonlyoperate usinganantenna
ofatypeandmaximum(orlesser)gainapproved
forthetransmitterbyIndustryCanada.To
reducepotentialradiointerferencetootherusers,theantennatypeanditsgainshouldbeso
chosenthattheequivalentisotropicallyradiatedpower(e.i.r.p.)isnotmorethanthat
necessaryforsuccessfulcommunication.

Conformémentàlaréglementationd’I ndustrieCa nada,leprésentémetteurradiopeut

fonctionneravecuneantenned’untypeetd’ungainmaximal(ouinférieur)approuvépour
l’émetteurparIndustrieCanada.Danslebutderéduirelesrisquesdebrouillageradioélectrique
àl’intentiondesautresutilisateurs,ilfautchoisirletyped’antenneetsongaindesortequela
puissanceisotroperayonnéequivalente(p.i.r.e.)nedépassepas
l’intensiténécessaireà
l’établissementd’unecommunicationsatisfaisante.



