User's Manual

Confidential & Proprietary 40/44
ThewaytoinstalltheALMIN/OUTConnectorcomplywithbelowprocedures


Figure23.HowtoinstallALMIN/OUTCabling
Theproceduresare
Peeloffsheathofthecable.
Assembleallcomponentsoncableasfollowing.
Connectallwirestoinsertaccordingtowirelist,thentightenallsmallscrews.
Thetorqueforsmallscrewsis0.2Nm.
Assembleplasticnuttomainbody.Recommendedtorque:1.0Nm.
(Note:The
keyinsidethemainbodymustgostraighttoslotofinsert.)
Push the cable seal,pinchringintothe main body, thentighten thepressurescrewintothebodywith
recommendedtorque:1.0Nm.