User's Manual

Confidential & Proprietary 8/41 THOR
“Only qualified personnel are allowed to handle this unit. Read and obey all the warning
labels attached in this user manual”
Any personnel involved in installation, operation or service of the SOLiD Technology repeaters must
understand and obey the following:
- Obey all general and regional installation and safety regulations relating to work on high voltage
installations, as well as regulations covering correct use of tools and personal protective equipment.
- The power supply unit in repeaters contains dangerous voltage level, which can cause electric shock.
Switch the mains off prior to any work in such a repeater. Any local regulations are to be followed when
servicing repeaters.
- The repeater cover should be (door) securely fastened in open position, e.g. by tying it up, at outdoor
work in order to prevent door from slamming due to wind causing bodily harm or damage.
- Use this unit only for the purpose specified by the manufacturer. Do not carry out any modifications or
fit any spare parts which are not sold or recommended by the manufacturer. This could cause fires,
electric shock or other injuries.
- Any DAS system or Fiber BDA will generate radio (RF) signals and continuously emit RF energy. Avoid
prolonged exposure to the antennas. SOLiD recommends maintaining a 500cm minimum clearance from
the antenna while the system is operating.
- Due to power dissipation, repeater may reach a very high temperature. Do not operate this unit on or
close to flammable materials.
- Do not use any solvents, chemicals, or cleaning solutions containing alcohol, ammonia, or abrasives.
- Certification
 FCC: This equipment complies with the applicable sections of Title 47 CFR Parts 15,22,24,27 and
90(Class B)
 UL/CUL: This equipment complies with UL and CUL 1950-1 Standard for safety for information
technology equipment,including electrical business equipment
 FDA/CDRH: This equipment uses a Class 1 LASER according to FDA/CDRH Rules.This product
conforms to all applicable standards of 21 CFR Chapter 1, Subchaper J, Part 1040
- A readily accessible disconnect device shall be incorporated external to the equipment
- This power of this system shall be supplied throughwiring installed in a normal building.If powered
directly from the mains distribution system, it shall be used additional protection, such as overvoltage
protection device.
- This equipment is classfied as Pollution degree 2
- Round terminals located on the rear of a 1.0mm2(16AWG) or more wires using permanently connected
to earth.