User's Manual
Table Of Contents
- Section1 Safety & Certification Notice
- Section2 System Overview
- Section3 System configuration and Functions
- 3.1 HROU (High power Remote Optic Unit)
- 3.1.1 Specifications of HROU
- 3.1.2 Block Diagram of HROU
- 3.1.2.1 HMRU block diagram
- 3.1.2.2 HROU inner look
- 3.1.2.3 HROU part list
- 3.1.3 Function by unit
- 3.1.3.1 High Remote Drive Unit (HRDU)
- 3.1.3.2 Remote Power Supply Unit ( RPSU)
- 3.1.3.3 Remote Optic(R OPTIC)
- 3.1.3.4 Remote Central Processor Unit (RCPU)
- 3.1.4 Bottom of HROU
- 3.1.4.1 Functions
- 3.1 HROU (High power Remote Optic Unit)
- Section4 System Installation
Figure 17. How to install Ground Terminal
The procedures are
1. Loosen a two M6 screws and then take compression terminal off
2. Insert AWG#6 Grounding Wire into terminal and then compress a terminal using tool
3. Assemble the terminal which made in step “2” using 2xM6 screws
4. Cut the ground wire to proper length and connect it to the earth ground source
( Round terminals located on the side of a 1 mm2 (16 AWG) or more wires Using permanently
connected to earth.)
4.1.7 HROU Optical cabling
The Optical Connector is located at the bottom of Remote Unit enclosure fixed. Optical Cable can be
connected by using connectors.
Confidential & Proprietary 36/44