User's Manual
Table Of Contents
- Section1 Safety & Certification Notice
- Section2 System Overview
- Section3 System configuration and Functions
- 3.1 HROU (High power Remote Optic Unit)
- 3.1.1 Specifications of HROU
- 3.1.2 Block Diagram of HROU
- 3.1.2.1 HMRU block diagram
- 3.1.2.2 HROU inner look
- 3.1.2.3 HROU part list
- 3.1.3 Function by unit
- 3.1.3.1 High Remote Drive Unit (HRDU)
- 3.1.3.2 Remote Power Supply Unit ( RPSU)
- 3.1.3.3 Remote Optic(R OPTIC)
- 3.1.3.4 Remote Central Processor Unit (RCPU)
- 3.1.4 Bottom of HROU
- 3.1.4.1 Functions
- 3.1 HROU (High power Remote Optic Unit)
- Section4 System Installation
4.1.5 HROU Power Cabling
AC Power
HROU supports AC110V/220V of input power. Provided outside power cable is only one type with
AWG#14 3m. Power cable is provided without power plug and it should be attached power plug based
on national’s power plug type
The pin discription of AC port is below. You should connect exact polarity of AC.
Port outlook MS Connector numbering Name Description
A : AC_H
B : AC_N
C : N.C
D : F.G
A AC_H AC Hot
B AC_N AC Neutral
C N.C Not Connected
D F.G Frame Ground
Check if the connection is the same as one seen in the table above and make sure to turn the power ON.
Provided AC power cable’s outlook is below
Confidential & Proprietary 32/44