User's Manual

Confidential & Proprietary 5/49
- For pluggable equipment, make sure to install the socket outlet near the equipment so that it
is easily accessible.
- Certification
 FCC: This equipment complies with the applicable sections of Title 47 CFR Parts 2, 27.
 UL/CUL: This equipment complies with UL and CUL 1950-1 Standard for safety for
information technology equipment,including electrical business equipment
 FDA/CDRH: This equipment uses a Class 1 LASER according to FDA/CDRH Rules.This
product conforms to all applicable standards of 21 CFR Chapter 1, Subchaper J, Part 1040
- A readyily accessible disconnect device shall be incorporated external to the equipment.
- This power of this system shall be supplied through wiring installed in a normal building.
If powered directly from the mains distribution system, it shall be used additional protection,
such as overvoltage protection device
- Only 50 ohm rated antennas, cables and passive equipment shall be used with this remote.
Any equipment attached to this device not meeting this standard may cause degradation and
unwanted signals in the bi-directional system. All components connected to this device must
operate in the frequency range of this device.
- Only 50 ohm rated antennas, cables and passive components operating from 150 - 3 GHz
shall be used with this device.
- The head end unit must always be connected to the Base Station using a direct cabled
connection. This system has not been approved for use with a wireless connection via server
antenna to the base station.
- Round terminals located on the side of a 1 mm2 (16 AWG) or more wires Using permanently
connected to earth. (Green/yellow color)
- Antenna installation
Antennas must be installed in accordance with FCC 27.50, 24, and SRSP 518, SRSP 516, SRSP
510 and SRSP 517. With 17dBi gain antennas the height of the antenna above average
terrain (HAAT) must not exceed 375m. For different gain antennas refer to the relevant
rules.