User's Manual

Confidential & Proprietary 45/49
Figure 4.27 – Priliminary Work for Installing AOR
The procedures are
1. Remove the dummy cover from the port that is used for connecting AOR.
2. The location of ports that need to be removed can be found in the figure No. 2 (The
ports are circled in red.). Use the same method of No. 1 to remove the dummy cover.
3. Install the inner I/O cable with the screws included in the package. Pay special attention
to the direction of connector when intalling them.
4. Connect the inner I/O cable to the defined connector of the RCPU.
5. Install two inner RF cables with the screws included in the package.
6. Check the names of the ports. Match and connect the external port with the correct R-
OPTIC port.