User's Manual

Confidential & Proprietary 14/39
3.2 Component of HERCULES Remote Unit
The following figure shows internal configuration of Remoe Unit with fully RF equipped.
2100AWS-1_MIMO RDU
700LTE_MIMO RDU
2100AWS-1 RDU
700LTE RDU
1900PCS RDU
850CEL RDU
RCPU
R-Optic
R-PSU(AC or DC)
CU1 (Multiplexer)
CU2 (Multiplexer)
Figure 3.2 – Inside of Remote Unit
Remote Unit receives TX optical signals from Head-End and converts them into RF signals. The converted
RF signals are amplified through High Power Amp in a corresponding RDU, combined with Multiplexer
module and then radiated to the antenna port.
When receiving RX signals through the antenna port, this unit filters out-of-band signals in a
corresponding RDU and sends the results to Remote Optic Module to make electronic-optical
conversion of them. After converted, the signals are sent to a upper device of ODU. ROU can be
equipped with up to six RDUs (Remote Drive Unit)