User's Manual
Confidential & Proprietary
5/39
-
Certification
FCC: This equipment complies with the applicable sections of Title 47 CFR Parts 15,22,24, 27
and 90
U
L
/
C
U
L
:
T
h
i
s
e
qu
i
p
m
e
n
t
c
o
m
p
li
e
s
w
i
t
h
U
L
a
nd
C
U
L
1950
-
1
S
t
a
nd
a
rd
f
or
s
a
f
e
t
y
f
or
i
n
f
or
m
a
t
i
on
technology equipment including electrical business equipment
FDA/CDRH: This equipment uses a Class 1 LASER according to FDA/CDRH Rules.
This product conforms to all applicable standards of 21 CFR Chapter 1, Subchaper J, Part 1040
-
A readuily accessible disconnect device shall be incorporated external to the equipment.
-
This power of this system shall be supplied through wiring installed in a normal building.
If powered directly from the mains distribution system, it shall be used additional protection, such
as overvoltage protection device
-
Only 50 ohm rated antennas, cables and passive equipment shall be used with this remote. Any
equipment attached to this device not meeting this standard may cause degradation and
unwanted signals in the bi-directional system.
-
All components connected to this device must operate in the frequency range of this device.
-
Only 50 ohm rated antennas, cables and passive components operating from 150 - 3 GHz shall be
used with this device.
-
The head end unit must always be connected to the Base Station using a direct cabled connection.
This
system has not been approved for use with a wireless connection via server antenna to the base
station.
-
Round terminals located on the side of a 1 mm2 (16 AWG) or more wires Using permanently
connected to earth.(green/yellow color)
-
Prior to equipment use the service must be registered with the FCC. This can be done through the
FCC’s website at https://signalboosters.fcc.gov/signal-boosters/.
-
Access can only be gained by SERVICE PERSONS or by USERS who have been instructed about the
reasons for the restrictions applied to the location and about any precautions that shall be taken;
and