User's Manual

Confidential & Proprietary 28/35

Theproceduresare
1. LifttheMRDUontotheguidebracketandensuretheMRDUislevellefttoright
2. PushtheMRDUintothecorrespondingslotinthedirectionoftheheatsinkwhilelevellingthe
MRDUtoguidebracket
3. Make sure the MRDU is firmly inserted into
 the corresponding slot. Tighten the 4 corner
screwstosecuretheunit
4. InstallMRDUblankcardsinallunusedslotsintheremote.Firstinserttheblankcardintothe
correspondingslot,thentightenthecaptivescrewtosecureit

3.1.7 HowtomountFANUnit
FANunitisrequiredtobeinstalledonthebottomofthe5Wremoteasshowninthebelowfigure.
In the case that MROU temperature on GUI exceeds 70℃ (1580F), the fan unit is required to be
installedonthebottomoftheremoteunit.


Figure4.14–
HowtomountFANUnit

