User's Manual

Confidential & Proprietary 14/39
3.2 Component of HERCULES Remote Unit
The following figure shows internal configuration of Remoe Unit with fully RF equipped.
Figure 3.2 – Inside of Remote Unit
Remote Unit receives TX optical signals from Head-End and converts them into RF signals. The converted
RF signals are amplified through High Power Amp in a corresponding RDU, combined with Multiplexer
module and then radiated to the antenna port.
When receiving RX signals through the antenna port, this unit filters out-of-band signals in a
corresponding RDU and sends the results to Remote Optic Module to make electronic-optical conversion
of them. After converted, the signals are sent to a upper device of ODU. ROU can be equipped with up to
six RDUs (Remote Drive Unit)