User's Manual

Confidential & Proprietary 58/59
The table below shows maximally available Composit Powerlevels that can be set per band:
RDU Band Composite power Setting range
700PS 44.5dBm 44.5 ~ 19.5dBm
700LTE 44.5dBm 44.5 ~ 19.5dBm
800PS 44.5dBm 44.5 ~ 19.5dBm
850Cellular 44.5dBm 44.5 ~ 19.5dBm
900I+Paging 44.5dBm 44.5 ~ 19.5dBm
1900PCS 44.5dBm 44.5 ~ 19.5dBm
AWS-1 44.5dBm 44.5 ~ 19.5dBm
AGS function enables you to adjust output power as you like. While the AGS function is being
executed, the Result window shows "Processing" and then a result value. There are three types
of results as follows:
A. Success: The AGS function is normally completed.
B. Not Opterate OPTIC Comp: Optic Comp is not executed yet.
C. Lack of ATT: There is no available attenuation.
Use various upper/lower limits. The following table shows recommended limit settings:
Item Recommended Limit Remark
TX OUT HIGH ALM Max Composit Power+1dB Alarm
TX OUTPUT LOW ALM 20dBm Alarm
TX OUTPUT ALC Max Composit Power Auto Level control
RX ALC -45dBm
TX OUTPUT HIGH ALM : If current value is higher than a setting value, alarm will be genrated.
TX OUTPUT LOW ALM : If current value is lower than a setting value, alarm will be genrated
TX OUTPUT HIGH ALM/LOW ALM tends to work only as warning.
When you activate (“ON”) RX ALC, inputs will be restricted depending on a setting value.