User's Manual

Confidential & Proprietary 57/59
5) RDU Setting
Mount RDUs you want to offer service up to 2 according to the procedurs described at chatper 5.
After all cables are connected completely, turn the RDU switch on. Check if the LED become
green. Through GUI, check if the ID of RDU module is inquired at 1
st
band and 2
nd
band. When
you select the tab of a corresponding slot (HMRU, HARU) from the main window of HROU, you
can inquire and set the status of a corresponding RDU module.
Figure 6.5 – Information HROU and RDU ID
If band ID is shown, cables connection and communication is well.
1) Turn TX AMP On/off on
2) After setting AGS leve you want to set and execute TX OUT AGS
3) Checking if TX OUT POWER is proper level you want to
4) Turn TX OUT SD on
5) Check if the alarms occurred. If alarm arise, refer to “troubleshooting manual”
Figure 6.6 – RDU Setting window