User's Manual

C
onfidential & Proprietary
Optical cables should be inserted into Optic Port outside of ROU. Using an optical slack devices
in ROU, you need to coil around one or two roll of cables to be connected with the optical
adaptor of ROPTIC.
At this time,
curvature of the optical cable should be at least 10Ø to prevent insertion loss from
being increased.
Through GUI, check if PD value of ROPTIC is in a tolerable range (+4~
5.3.4 GND Terminal
Connection
ROU has one GND terminal port where is on bottom
onfidential & Proprietary
90/139
Optical cables should be inserted into Optic Port outside of ROU. Using an optical slack devices
in ROU, you need to coil around one or two roll of cables to be connected with the optical
curvature of the optical cable should be at least 10Ø to prevent insertion loss from
Through GUI, check if PD value of ROPTIC is in a tolerable range (+4~
-
1dBm).
Connection
ROU has one GND terminal port where is on bottom
side, like below
Optical cables should be inserted into Optic Port outside of ROU. Using an optical slack devices
in ROU, you need to coil around one or two roll of cables to be connected with the optical
curvature of the optical cable should be at least 10Ø to prevent insertion loss from
1dBm).