User's Manual

C
onfidential & Proprietary
5.5.3 GND Terminal
Connection
AOR has one GND terminal port where is on rear side, like below
- Take off the GND
terminal port from enclosure and connect to ground cable, then fix it
the position of enclosure again
- T
he opposite end of the ground cable should connect to the communication GND of
building
- T
he ground lug is designed meeting the SQ22 standard
5.5.4 Coaxial
cable and Antenna
-
AOR has two antenna port, the one is TX antenna and the others is RX antenna
- T
he coaxial cables which are connected to antenna distribued networ
antenna port of AOR
whether it is within specification using SITEMASTER .
- A
t this time, check if the Return loss have above 15
- T
he part of antenna connection fasten to port not to be loosed and not to be injected
the dusty and insects
- The antenna
connected to
5.5.5 Consumption
Power
The following tabl
e shows power consumption
Part
AOR
RDU VHF+UHF
(E_VHF+UHF)
onfidential & Proprietary
112/139
Connection
AOR has one GND terminal port where is on rear side, like below
terminal port from enclosure and connect to ground cable, then fix it
the position of enclosure again
he opposite end of the ground cable should connect to the communication GND of
he ground lug is designed meeting the SQ22 standard
cable and Antenna
Connection
AOR has two antenna port, the one is TX antenna and the others is RX antenna
he coaxial cables which are connected to antenna distribued networ
antenna port of AOR
. Before connection, check the VSWR value of co
whether it is within specification using SITEMASTER .
t this time, check if the Return loss have above 15
Db
or VSWR have below 1.5
he part of antenna connection fasten to port not to be loosed and not to be injected
the dusty and insects
connected to
AOR is only serviced in inbuilding
Power
of AOR
e shows power consumption
s of AOR:
Unit Consumption Power
RDU VHF+UHF
(E_VHF+UHF)
VHF 47W
VHF
UHF
47W
UHF
FULL 74W
Both HPA ON
terminal port from enclosure and connect to ground cable, then fix it
he opposite end of the ground cable should connect to the communication GND of
AOR has two antenna port, the one is TX antenna and the others is RX antenna
he coaxial cables which are connected to antenna distribued networ
k connect to two
. Before connection, check the VSWR value of co
axial cable
or VSWR have below 1.5
he part of antenna connection fasten to port not to be loosed and not to be injected
Remark
VHF
HPA OFF
UHF
HPA OFF
Both HPA ON