User's Manual

C
onfidential & Proprietary
ID Setting
Use an RS-
232 Cable(Direct Cable) for co
(Graphic User Interface). When you connect
show the TREE of a direct line of units connected with
DOU1. Set it with the ID of a designed
ROU is connected with the optical port of ODU
The sort of OEU ID
The sort of OEU ID is as below
OEU is connected only to 4
th
optical port of DOU1/2 in the ODU1/2
T
herefor, it need to assign upper unit connected to ODU#
If multiple OEU
s connected to
information on the OEU
s with the same I
ID.
onfidential & Proprietary
132/139
232 Cable(Direct Cable) for co
nnection with DEBUG port of OEU
(Graphic User Interface). When you connect
OEU
directly with a Serial port, the screen will
show the TREE of a direct line of units connected with
OEU. Basic OEU
ID is set as ODU1
DOU1. Set it with the ID of a designed
OEU. Before setting an OEU
ID, you need to check if
ROU is connected with the optical port of ODU
The sort of OEU ID is as below
optical port of DOU1/2 in the ODU1/2
herefor, it need to assign upper unit connected to ODU#
-DOU#
s connected to
BIU
share the same ID, the screen will fail to read status
s with the same I
Ds. Therefore, make sure not to redundantly set
nnection with DEBUG port of OEU
. Execute GUI
directly with a Serial port, the screen will
ID is set as ODU1
-
ID, you need to check if
share the same ID, the screen will fail to read status
Ds. Therefore, make sure not to redundantly set
OEU