User's Manual

Confidential & Proprietary 60/139
Figure 4.35 – AOR Rear Look
Item Description Remark
1. VHF/UHF TX IN Terminal for receive the signal of TX from existing ROU
2. VHF/UHF RX OUT Terminal for transmit the signal of RX to existing ROU
To/From
Existing
ROU
3. Power Port
Terminal for input either AC 110V or DC-48V as internal
PSU type
4. VHF/UHF TX IN Terminal for radiate the signal of TX to TX Antenna
5. VHF/UHF RX OUT Terminal for receive the signal of RX from RX Antenna
To/From
Antenna
5.External Port Port for communicate with existing ROU
6.GND LUG PORT Terminal for system ground
POWER PORT
Power ports are used for power-supplying of -48V DC or 120V AC, and specific power
cable should be applied to each different types of ROU power supply (AC/DC or
DC/DC). Below figure is naming of the power supply by type.