User's Manual

Confidential & Proprietary 7/26 SC-DAS

users. This power reduction is to be by means of input power or gain reduction and not by an attenuator

at the output of the device."

- The power of this system shall be supplied through wiring installed in a normal building.

If powered directly from the mains distribution system, it shall be used additional protection, such as

overvoltage protection device

- Only 50 ohm rated antennas, cables and passive equipment shall be used with this remote. Any

equipment attached to this device not meeting this standard may cause degradation and unwanted

signals in the bi-directional system. All components connected to this device must operate in the

frequency range of this device.

- Only 50 ohm rated antennas, cables and passive components operating from 150 - 3 GHz shall be used

with this device.

- The head end unit must always be connected to the Base Station using a direct cabled connection.

This system has not been approved for use with a wireless connection via server antenna to the base

station.

- Round terminals located on the side of a 12 AWG or more wires Using permanently connected to

earth.(green/yellow color)

- This is only to be used with BTS devices supporting licensed cellular operations

- Access can only be gained by SERVICE PERSONS or by USERS who have been instructed about the

reasons for the restrictions applied to the location and about any precautions that shall be taken; and

- Access is through the use of a TOOL or lock and key, or other means of security, and is on trolled by the

authority responsible for the location.

- Certification

 FCC: This equipment complies with the applicable sections of Title 47 CFR Parts 15,22,24,27 and

 UL/CUL: This equipment complies with UL and CUL 1950-1 Standard for safety for information

technology equipment,including electrical business equipment

 FDA/CDRH: This equipment uses a Class 1 LASER according to FDA/CDRH Rules.This product

conforms to all applicable standards of 21 CFR Chapter 1, Subchaper J, Part 1040

- Repeater warning label message should include