User's Manual

3. Instruction
 CHI WB-60 has a IPX5 water-proof design
 Wireless charging
 When battery has no connection with power via USB(Power bank
mode)
1. Confirm the handset has wireless-charging function
2. Put the handsets’ wireless charging wire location onto the
SHO-U logo(SHO-U is the location of wireless charging wire)
3. Press the red button to charge the handset
4. When the green LED illuminates, the charging starts
5. When the handset leaves the device for over 20 seconds, the
device will stop charging for energy-saving and protection
6. After 20 seconds passed after the handset leaved the device,
if you want to continue charging, please repeat 1~4
 Wireless charging(device connected with USB cable to be
charged)
1. Confirms the handset has wireless charging function
2. Put the handset onto the device, the wireless charging
wire’s location must touch the SHO-U logo
3. Wirelessly charge the handset directly
4. When the green LED illuminates, the charging starts
5. When the handset leaves the device, the wireless power bank
will be charged
6. When the handset was put onto the device, it will detect
the handset automatically and charge the handset, the red
button will not need to be pressed again
 Charging with USB cable(power bank mode)
1. Use the attached or suitable USB cable to connect the device
and the handset, press the red button to charge the handset
2. Everytime you unplug the USB cable and plug in it again, please
press the red button again
 Wireless power bank capcity check
 When the red button is pressed or it’s charged with USB cable,
the device will have the capacity LED(blue) blink to indicate the
capacity
1. capacity<25% ：LED1 blinks
2. capacity in 25%~50%：LED1 on，LED2 blinks
3. capacity in 50%~75%：LED1，LED2 on，LED3 blinks
4. capacity in 75%~100%：LED1，LED2，LED3 on，LED4 blinks
5. capacity in 100%，LED1~LED4 on
4. Protection and indication
 Over-current protection of charging output(2.6A over-current
protection)
 When it detects the output current exceeds 2.6A, the charging to
the handset will be stopped, and the 4 LEDs will blink for 5
seconds warning then cease(blink 0.25 seconds, cease 0.25
seconds)
 Charging output short protection
When the device detects the short, the output will be stopped to
charge the handset, when the short symptom disappears, the
charging will be recovered automatically
 NTC temperature protection function