User Manual
Table Of Contents
- Introduction
- 1. Nucleus2 Overview
- 2. Nucleus2 Configurations
- 3. Software Installation
- 4. Connection and Software Configuration
- 5. Nucleus2 Remote
- Establishing the Remote Connection
- Remote Tabs
- Remote Layer Selection
- Layer Profile Configuration
- Timeline Functions
- Soft Key Configuration
- Default Soft Keys
- User 1, User 2 Soft Keys
- Transport / Utility Soft Keys
- Assigning Soft Key Functions
- DAW Protocol Commands
- DAW Keyboard Shortcuts
- Soft Key Menus
- Renaming Softkey Assignments
- Assigning Modified Functions to Soft Keys
- Removing and Replacing Soft Key Assignments
- Configuring Continuous Controller Layers
- 6. DAW Operations
- 7. Analogue Operations
- Appendix
- Index
Page 4 Nucleus
2
User Guide
CENTRE SECTION AND ANALOGUE CONTROL
Nucleus
2
REMOTE
Analogue Control:
Monitoring and
Mic inputs
Channel/Bank
scrollers
* Transport
Control
USER Soft Key
Set selectors
Additional DAW
Layer Selectors
DAW Channel
Control modifiers
DAW Computer
modifier keys *
* Global DAW
Control keys
Note
The function of switches in
areas with asterisks are
defined in the Nucleus
2
Remote.
(Default functions are shown.)
Defines which layer
is being edited
in the Remote
Defines the DAW
being controlled
Selects soft key
sets for the Soft Key
Setup display
Soft Key Setup
Enables single-letter
automation display
Defines which DAW
is transport master
Select DAW to view or
edit Nucleus
2
setup
Defines default
function of Jog Wheel