User Manual
Table Of Contents
- Introduction
- 1. Nucleus2 Overview
- 2. Nucleus2 Configurations
- 3. Software Installation
- 4. Connection and Software Configuration
- 5. Nucleus2 Remote
- Establishing the Remote Connection
- Remote Tabs
- Remote Layer Selection
- Layer Profile Configuration
- Timeline Functions
- Soft Key Configuration
- Default Soft Keys
- User 1, User 2 Soft Keys
- Transport / Utility Soft Keys
- Assigning Soft Key Functions
- DAW Protocol Commands
- DAW Keyboard Shortcuts
- Soft Key Menus
- Renaming Softkey Assignments
- Assigning Modified Functions to Soft Keys
- Removing and Replacing Soft Key Assignments
- Configuring Continuous Controller Layers
- 6. DAW Operations
- 7. Analogue Operations
- Appendix
- Index
Page 40 Nucleus
2
User Guide
USER KEYS
T
wo so keys sets are available for users to congure. These so keys employ the Mode and V-Sel switches in channels
9
-16:
The two soft key sets are called User 1 and User 2, and are activated by pressing the USER or USER switch, below the
Nucleus
2
logo in the centre section. The top row of the scribble strip display indicates the Mode switch function, the
bottom row the V-Sel function. To return the Mode and V-Sel switches to their normal functions, deselect both USER or
USER switches.
Each Mode switch can be run either as a simple soft key (triggering any DAW computer keyboard command or any
command within the relevant DAW protocol), or as a menu switch – each menu switch accesses a subset of soft keys laid
out across the V-Sel switches below:
Taking the V-Sel assignments which will be active with no Mode switches selected in to account, the two USER soft key
sets can be configured to provide access to up to 144 functions. This is of course in addition to all of the other user-
assignable switches across the control surface.
The
USER
and
USER
soft key sets are programmed using the Nucleus
2
Remote, as described in Section 5.