User Guide

Fusion User Guide Fusion User Guide
Settings Mode & Factory Reset Settings Mode & Factory Reset
16 17
Factory Reset
To reset Fusion to factory settings, switch the unit on then hold down the VINTAGE DRIVE IN and BYPASS switches during the
startup LED sequence.
Factory Reset allows reset of any stored settings (Brightness, Relay feedback, BYPASS and INSERT configurations) to the factory
default. Press and hold the combination of switches until all the switches start flashing. After releasing the switches, the unit will
automatically reboot and the factory settings will be restored.
Simon Says Game
To play the Simon Says game, switch the unit on and hold down all four IN switches during the startup LED sequence.
The BYPASS switch will flash red. The highest score achieved on the unit is shown on the master meters; the right bar meter is
points x1, the left bar meter is points x10 (e.g. two LEDs lit on the left and six LEDs lit on the right means that the current highest
score is 26). If the maximum score is reached, the two top red LEDs are lit. Factory reset does not affect the highest score for the
unit.
1. Press the flashing BYPASS switch to start a round.
2. A random switch between the first four switches will light up briefly (The relay will also click a number of times equal to the
position of the switch; switch 1 = 1 click, switch 2 lit = 2 clicks etc).
3. The aim of the game is to press the correct switch within four seconds. If the wrong switch is pressed or a timeout of four
seconds elapses, the game resets.
4. If you press the correct switch, you move to the next level and another switch is added to the sequence.
Note: Every three levels the difficulty increases by displaying the sequence faster.
To exit this mode, simply power -cycle the unit.
+ +
VINTAGE DRIVE
+ + + +
VINTAGE DRIVE
1 2 3 4
VIOLET EQ HF COMPRESSOR STEREO WIDTH
Settings Mode & Factory Reset
This section will detail how to enter Fusion's Settings Mode and the functionality that can be changed. It also details how to reset
Fusion back to a factory default state.
Entering Settings Mode
To enter the Settings Mode, switch the unit on then hold down the TRANSFORMER and BYPASS switches during the startup LED
sequence. In this mode it is possible to modify some parameters of the unit. These parameters will be recalled each time the unit
is rebooted.
Brightness
Whilst in Settings Mode, it is possible to select five levels of brightness for the meters and switches.
➤ To decrease the brightness, press the VINTAGE DRIVE IN switch.
➤ To increase the brightness, press the VIOLET EQ IN switch.
If the VINTAGE DRIVE IN switch is not lit, minimum brightness is reached. If the VIOLET EQ switch is not lit, maximum brightness
is reached. Factory setting: maximum brightness.
Note: The brightness setting does not affect the startup LED sequence, or signal indicator LEDs found in the
VINTAGE DRIVE and HF COMPRESSOR sections.
Relay Feedback
Whilst in Settings Mode, it is possible to enable or disable the relay feedback of the switches. This affects the startup sequence
and normal operation. To switch between enabled and disabled, press the INSERT IN switch.
➤ If INSERT is dimly lit white, relay feedback is disabled.
➤ If INSERT is lit blue, relay feedback is enabled (a quick relay transition is reproduced as confirmation of the setting).
Factory setting: relay feedback enabled.
Exiting Settings Mode
To exit Settings Mode, press and hold the BYPASS switch until the unit reboots.
+ +