User Manual

Table Of Contents

Duende Native User Guide Page 53

. Adjust the Detail Parameters

etail parameters are adjusted in the Reverb Control area of the window, located between the Input and Output areas. The

R and REV buttons in the top left-hand corner of the display define whether the ER (Early Reflections) or REV (Reverb)

arameters, graphs and sub-menus are displayed.

If ER is selected, the ER Master Del (delay), Master Lev (level) and Master Time knobs appear below the graph and to the left.

In addition, six buttons appear to the right of the ER button, labelled L1, L2, L3, R1, R2 and R3. These define which of the six

Left and Right early reflection ‘taps’ are being edited using the three further buttons which further to the right: Main, Mod

and Filter. By selecting one of these three buttons, the controls for their parameters appear below the graph and to the right.

The area between the ER controls and the Main, Mod or Filter controls indicate which ER ‘tap’ is being edited, and which set

of parameters are displayed to the right – the appropriate symbols light up.

The following diagram illustrates which controls are available when each button is selected. Each parameter is defined in the

table on Page 60. The table on Page 56 indicates which of these parameters are affected by the Primary parameters.

When ER parameters are active, the graph displays the

ER Box in pink. This represents the loudest and longest

ER taps. Each tap (L1, L2, L3 and R1, R2, R3) has a

handle which can be clicked/dragged horizontally to

adjust the Delay time, or vertically to adjust the tap’s

Level. The stem beneath each node is coloured red for

left, or green for right.

The handle half way along the top of the ER Block

adjusts the Master Level (increasing/decreasing the

individual taps levels relatively), the handle half way

down the right side of the ER Block adjusts the Master

Time (increasing/decreasing the individual taps delays relatively).

While the ER Box is displayed, the REV triangle is always visible in the background. Clicking on the REV triangle will switch

the Reverb Control area to REV and the sub page to Reverb.

Main controls

Delay, Level, Phase, Pan

Mod controls

Filter controls

ER Rebound, Cutoff Freq

Master Controls

Master Del, Lev, Time Cho Rate, Cho Depth