User Manual

Duende Native User Guide Page 49
I
nput and Output Levels
T
he input and output sections at either side of the plug-in window provide input and output gain control, along with level
m
etering and clip lights:
Mix Levels
The Mix area towards the top right-hand corner of the display controls the mix between Early Reflections
(ER) and reverb (REV), as well as the mix between the un-processed (Dry) and processed (Wet) signals.
A number of presets are available – click on the box to the right of the Mix label and select one from the
drop-down menu.
The Bus and CH prefixes indicate the Dry – Wet mix:
Bus presets have a 100% Wet mix, for when X-Verb
is being used in an auxiliary bus where it has an
independent level control.
CH presets default to a 50-50 mix. Use CH when
X-Verb is being used within a track, and you need to
mix a smaller amount of the reverb signal with the
original.
In the ER/REV presets, both ER and REV signals are
at full. In the ER presets, the level of the REV signal
is halved, and in the REV presets, the level of the ER
signal is halved.
100% REV100% ER
Wet
Dry
Bus REVBus ER/REVBus ER
CH REVCH ER/REVCH ER
Peak Meter
Displays the signal level. Input meter is pre-input
fader, Output fader is post-outputdaer
RMS Meter
The thinner bar to the right shows
the RMS (average) level over time.
Clip Light
Indicates that the signal is clipping. It clears
after 1 second, or click on it to clear manually.
Level Controller
Move the semi-transparent bar up
and down to control the level