User Manual

Page 20 Duende Native User Guide
INTERFACE TECHNIQUES
•
To press a switch in a plugin, simply click on it.
•
To turn a knob, click on it, and drag it up and to the right (as shown right). If your mouse has a scroll
w
heel, you can also turn knobs by hovering over them and turning the scroll wheel.
• To turn a knob slowly for fine adjustments, hold
Shift on your keyboard whilst turning.
• To reset a knob to its default value, click on it whilst holding Ctrl (Windows) or ⌘ (Macintosh).
• To view the value for any knob, hover over the knob cap with the mouse.
The current value will appear immediately above the knob (shown right).
Automation
Every plug-in parameter can be automated in host applications which support automation. The method for recording and
editing automation varies from host to host. For specific instructions on using automation within the host, consult the host
application documentation.
INPUT SECTION
Turn the GAIN knob to control the level of the incoming audio signal. The post-gain signal level is shown
to its left. As a rough guide, the ‘-6’ yellow indicator should occasionally comes on but the red ‘0’
indicator should remain off.
Press Ø to invert the phase of the input signal.
FILTER SECTION
There are two filters in the Filter section:
• The black knob controls an 18dB/Octave high pass filter (20Hz to 500Hz).
• The purple knob controls a 12dB/Octave low pass filter (3kHz to 22kHz ).
Filters are inactive when turned fully left (OUT). Turn them clockwise to move the filter frequency in
from its extremity.
To place the Filters straight after the input control, press INPUT (see previous page), and to switch the Filters into the
Dynamics sidechain, press DYN SC (see Page 27 for more info). Note that these switches cancel each other out.
Value will
appear above
Place mouse
over knob
C
lick
+ Drag