Installation & Assembly

8
you will be overlapping with the panel above it first). Attach the next panel above the first so it
overlaps (like a shingled roof) the panel below it by 1-1½” (3-4cm). Attach screws 4-6” (10-15cm)
apart along the greenhouse supports where the panels overlap. The process is repeated until
you approach the peak of the greenhouse. Repeat the process on the opposite side of the
greenhouse. The last step is to install the top cap where the two sides meet at the peak.
Maintenance
Repair
If you happen to get a small hole in your Solexx, we suggest you fill it with silicone caulking. For
larger holes, a section of Solexx can be replaced between the bows.
Cleaning
Wipe down Solexx with soap and water once a year to maintain maximum efficiency of light
transmission. Solexx is inert so you can safely use a mild bleach solution to disinfect your
greenhouse without the risk of harmful BPA gases.
Technical Support
One of the services we offer Solexx customers is the ability to easily access our Technical Support
Manager in Salem, Oregon. If you have any technical support questions before, during or after
your Solexx installation, please call 877-217-3260 and talk with Bryen Boes. Bryen is available 8-5
pm Pacific Time (PT), or arrange an appointment for your convenience.
Disclaimer
Information contained in this guide is for information purposes only. Adaptive Plastics does not
warrant any of the above information. During installation, the customer assumes all risk and
Adaptive Plastics assumes no liability. Ultimately the person installing the Solexx should use their
own best judgment.
Solexx and Adaptive Plastics are trademarks of Adaptive Plastics, Inc.