Installation & Assembly

2
Getting Started
Maximizing Insulation
To maximize your greenhouse insulation, attach Solexx on the outside of the frame so it covers
all the metal surfaces. Exposed metal pipes and polycarbonate metal framing reduce the
insulating capacity of all greenhouse coverings by acting as a conductor in transferring the
outside cold into the greenhouse. Since Solexx attaches to the outside of the frame, the
greenhouse’s ability to conserve energy is optimized.
Orientation
There is no right or wrong side when installing Solexx. Both sides can face the sun since the UV
protection is dispersed throughout the glazing. Install Solexx either vertically or horizontally
depending on the best application for your structure. Each option offers a variety of advantages:
Horizontal: Flutes Across the Structure
 Ability to use a combination of widths to provide coverage at a potentially lower price
 Less seams, cuts and caulking
 Increase structural strength with Solexx spanning across and screwed into every bow
 Allows for roll-up polyethylene film sides
Vertical: Flutes to the Ground
 Ability to buy a width to match your on-center spacing – 4’(1.21m), 5’(1.52m) or
6’(1.83m)
 Ability to arrange seams to minimize impact of wind
 Ability to use wire cabling and not install additional greenhouse supports
 Allows for roll-up polyethylene film sides
Solexx Installed Vertically
Solexx Installed Horizontally