Use and Care Manual

8) Bucket Full - When the water bucket is full of water, the unit will automatically shut off , make a beeping
noise, and the Bucket Full Indicator will light up. The dehumidifier will not function until the water bucket
is emptied and placed back inside the unit. The bucket should be cleaned every few weeks to prevent the
growth of mold, mildew and bacteria. Use a mild detergent to clean the bucket. Once clean, completely dry
the bucket and place it back inside the dehumidifier.
NOTE: When the bucket is full or removed from the machine, the compressor will turn off, but the fan
will continue to run for a few minutes. This is completely normal. The dehumidifier will not be remov-
ing moisture from the air at this time.
NOTE: When removing moisture from the air, the dehumidifier will exhaust warm air from the top ex-
haust vent.
9) Clean Filter - When the filter needs to be cleaned, the filter indicator will light up (after 250 hours of use).
Remove the filter from the front of the unit by completely removing the dehumidifier bucket with two hands
and then pulling down on the filter tab directly below the front intake grill. Clean the filter with warm, soapy
water. Dry thoroughly before replacing the filter. Once the filter is completely dry, place the filter back in the
unit and press the FILTER button to reset the filter indicator.
CAUTION: DO NOT OPERATE THE DEHUMIDIFIER WITHOUT THE INCLUDED FILTER
OPERATING INSTRUCTIONS
NOTE: Do not clean filter in dishwasher