ADDRESS: Soleus International, Inc. 20035 E. Walnut Dr. N., City of Industry, CA 91789 WEBSITE: www.soleusair.com TEL: (888) 876-5387 SG-DEH-70EIP-6 Portable Dehumidifier with Internal Pump Operating Instructions V.
TABLE OF CONTENTS Package Contents ........................................2 Warranty .......................................................2 Safety Instructions ........................................3 Electrical Requirements ...............................4 Installation .................................................4,5 Placement…. ................................................5 Control Panel ............................................ ...6 Dehumidifier Operation...………....................
NOTES _____________________________________________________________________ _____________________________________________________________________ _____________________________________________________________________ _____________________________________________________________________ _____________________________________________________________________ _____________________________________________________________________ _____________________________________________________________________ ________________
Dehumidifier Facts ELECTRICAL REQUIREMENTS OBSERVE ALL LOCAL CODES AND ORDINANCES. RECOMMENDED GROUNDING METHOD For your personal safety, this appliance must be grounded. This appliance has a power supply cord with a 3-prong grounded plug. To minimize possible shock hazard the cord must be plugged into a matching grounded electrical outlet that complies with the latest edition of the National Electrical Codes and all local codes and ordinances.
ERROR CODES CHOOSING THE PROPER LOCATION Error Code Error Type Possible Cause Corrective Action AUTOMATIC SHUT OFF When the bucket is full, or when the bucket has been removed, the compressor will automatically stop. The fan will continue to blow to dehumidify for 3 minutes. Then the Bucket Full indicator will flash and you will hear a ten second audible alarm. The bucket must be placed in the proper position for the dehumidifier to work.
TROUBLESHOOTING (Cont.) CONTROL PANEL Problem Dehumidifier runs too much (12) The capacity of your dehumidifier may not be adequate for the room size. Doors and windows are open. Close all doors and windows to the outside. Frost appears on the coils The dehumidifier has recently been turned on or the room temperature is below 41°F. This is normal. Frost will usually disappear within 60 minutes.
TROUBLESHOOTING Problem Possible Causes Solutions Dehumidifier does not start. The dehumidifier is unplugged. Make sure the dehumidifier’s plug is pushed completely into the outlet. The fuse is blown / circuit breaker is tripped. Check the house fuse / circuit breaker box and replace fuse or reset breaker. Dehumidifier has reached the user set humidity level or the bucket is full. The dehumidifier automatically turns off when either condition occurs.
WATER DISPOSING OPTIONS OPTION 1: EMPTYING MANUALLY 1. Pull out the bucket, grasping the side handles. (Fig. 1) 2. Carry the bucket by grasping the front corner of the bucket with one hand and the back of the bucket with the other hand( Fig. 2) 3. Empty the bucket and replace the bucket in the dehumidifier. (Fig. 3) NOTE: Dehumidifier will not work and settings can not be changed when the BUCKET FULL indicator light is flashing or without the bucket properly installed. (FIG. 1) (FIG. 2) (FIG.
WATER DISPOSING OPTIONS USING THE DEHUMIDIFIER NOTE: When installing the pump hose, the unit must be running in PUMP MODE. Water is pumped a maximum of 16 vertical feet. Do not exceed 16 feet for proper operation. There is a small backup water tank inside the dehumidifier. When using PUMP mode the backup water tank fills up and then water is pumped out of the dehumidifier when full. Step 2: Thread a garden hose (not supplied) onto the drain nozzle. (Fig.
INSTALLING THE PUMP HOSE OPTION 3: USING THE INTERNAL VERTICAL PUMP - Only install when using pump mode! INSTALLING THE INTERNAL PUMP HOSE Step 1: Remove the bucket from the dehumidifier (Fig. 8) INSTALLING THE PUMP HOSE Step 4: Insert the pump hose onto the pump hose connector. Push the clamp towards the connector to secure the connection. (Fig. 11). (FIG. 11) (FIG. 8) Step 2: Remove the pump hose connector from the top of the bucket. It is located to the left of the bucket handle. (Fig. 9) (FIG.
