User Manual
Connect the NCC Communication cartridge to the Master Radio Module 3-
Pin connector with the cable provided with the NCC as shown Sch.2-A.
If the IQ Satellite is a SERVER satellite of an IQNet (share information with
other CLIENT ESP-LX), then you need a IQ Connection Module. Use the
straight double 3-pin cable provided with the Master Radio Relay to
connect the connection module to the Master Radio Relay 3-pin connector
(Sch.2-B)
INITIAL
S
T
AR
T-UP
Radio M
a
r
k
i
ng
Radio marking is a key step during installation of a radio device.
To be able to communicate via radio, all radio devices (Field Transmitter, Radio Adaptor,
Master Radio Module and TBOS Radio Relay) must ha
ve
th
e
sam
e
Radio
Ne
two
rk
Number. The
Radio Network Number is a 4-digit code transmits to any radio device by the TBOS-II™ Field
Transmitter during its Radio Marking. The Radio Network Number secures your network by
limiting risk of interferences with other IQ-TBOS networks.
The Radio Marking is done in 3 simple steps:
- On the Field Transmitter, go on Radio Marking screen (TBOS Radio Menu / Radio
Marking)
- For IQ-TBOS Master Radio Module, activate the “waiting” mode by unplugged /
plugged the Module onto the ESP-LX platform – During 20 seconds the module is
waiting for its Radio Network Number.
- Validated by pressing OK on the Field Transmitter within the 20 seconds.
Radio Marking is only done once, at first installation.
When all radio devices are marked with a common Radio
Ne
two
rk
Number, network building
could be launched from IQ software.
Radio Network Number
C
us
t
om
i
z
at
i
on
It is highly
re
comm
e
nd
e
d
to customize the Radio Network Number of each Radio
N
e
t
w
o
r
k
.
UT
I
L
I
Z
A
T
I
ON
Automatic finding of Radio
R
e
l
ay
s
Then launch a radio finding command with your TBOS-II™ Field Transmitter in order to detect
the Radio relays (See TBOS-II™ Field Transmitter user guide)
The list of radio relays within the Field Transmitter radio range (TBOS Radio Relays and IQ-
TBOS Master Radio Module) is displayed on transmitter screen. From this list you are able to:
- Rename a relay
- Launch an automatic finding command of TBOS™/TBOS-II™ controllers equipped
with TBOS-II™ Radio Adaptors. All settings and programming operations of the
controllers are doable from your transmitter, thru the relay.
- Launch an automatic finding command of primary or secondary relays