Owner Manual

Support Strips
This step is to ensure that the bottom of the sink has enough support.
Construct a wood support frame to fit inside the cabinet opening. Allow adequate clearance for the water supply
lines and drainage system.
The recommended support frame design is shown in the illustration on the left, which consists of four vertical
supporting strips, two horizontal supporting strips and one supporting board. Due to the variety of installations
possible with this sink, your installer may suggest a different support frame design.
IMPORTANT:
Base cabinet and wood support frame are essential for proper installation. The weight of the sink
when full is approximately 300 lbs. Base cabinet and support frame must sufficiently support this weight.
Support Board
Using two people, carefully place the sink in place. Verify that the sink
can fit in the cabinet opening and rest properly on the supporting system.
Make a small adjustment to fit as necessary.
Verify the overall appearance and check for levelness to ensure correct
drainage.
IMPORTANT:
Risk of personal injury or product damage. Handle with care.
The product can break, chip, cause injury or product damage.
STEP3: CABINET/SUPOORT FRAME CONSTRUCTION
STEP4: SINK INSTALLATION