Installation & Assembly

PAGE 1

Before You Start

• Soleil Sinks recommends that all ceramic sinks be installed by an experienced, professional installer.

• IMPORTANT: The enclosed cutout template will create a countertop opening with a minimal (1/8” or less) reveal. It is

recommended that you discuss with your installer and agree that the nished appearance is the desired effect. Soleil Sinks

is not responsible for improper sink or countertop installations.

• IMPORTANT: The cabinet must be installed, secured, plumb, and level. Failure of this step can lead to product damage.

• Soleil Sinks’ ceramic sinks should only be fastened to a solid surface countertop (i.e. granite, Corian® or Silestone®).

• Soleil Sinks is not responsible for sink or countertop if damaged during installation. Be sure to inspect the sink for damage

prior to beginning installation.

• Ceramic edges may be sharp – use caution when handling.

• Follow all local plumbing and building codes.

Recommended Tools & Materials (Not Included)

 Tape Measure

 Safety Glasses

 Painter’s Tape

 Level

 Ear Protection

 Hacksaw/Jigsaw

 Shims or Cabinet Fillers

 Denatured Alcohol

 Mounting Clips

 Construction Adhesive

 Silicone Adhesive Sealant

SS209 Oval Vanity Sink SS210 Oval Vanity Sink

SS1811 Rectangular Vanity Sink SS1813 Rectangular Vanity Sink

Ceramic Sink

Installation Instructions

PAGE 1
Ceramic Sink Installation Instructions SS209 Oval Vanity Sink SS210 Oval Vanity Sink SS1811 Rectangular Vanity Sink SS1813 Rectangular Vanity Sink Before You Start • Soleil Sinks recommends that all ceramic sinks be installed by an experienced, professional installer. • IMPORTANT: The enclosed cutout template will create a countertop opening with a minimal (1/8” or less) reveal. It is recommended that you discuss with your installer and agree that the finished appearance is the desired effect.
PAGE 2
Ceramic Sink Installation Instructions 1. Unpack the new sink and check the contents of the materials supplied: sink, mounting brackets and cutout template. 2. Cut out the appropriate template for your sink model and desired installation option. Place template in desired position on countertop, locating center of the bowl over cabinet and faucet holes. 3. Trace the outline of the template and cut countertop along the inside of the line using the appropriate cutting tools.