User's Manual

Figure 2-6: Rack-mount BTS Enclosure
2.4 Connection of Ethernet Cable
The following diagram (Fig 2-7) shows the connections between the BTS and a network
switch. The data interface on the BTS is Ethernet with standard RJ-45 connector, as
shown below in Figure 2-7.
Figure 2-7 RJ-45 Ethernet Connector
Fabricate the Ethernet cable using the RJ-45 connectors shown in Fig 2-7. Connect one
end to the Ethernet port located on the bottom left side of the BTS front panel as shown
in Fig 2-8 and the other to a network switch or other transmission equipment.