User's Manual

accessories to move the U-shape opening on the corresponding round steel bar of the
cabinet support, as show in Figure 2-5.
Figure 2-4 Bottom of the cabinet
Position the cabinet, make it sit flat by using a level and then tighten the expansion bolts.
Check the insulation impedance with a meg-ohmmeter between the cabinet and the floor
and make sure that the value is greater than 5MΩ.
2.3 BTS Installation
The overall structure of the BTS is shown in Figure 2-5.
Open the cabinet door, adjust the partition positions, push the BTS into the sub-rack.
Record the model and Factory No. of the BTS and cable loss data for future references.
Keep this set of information at an easily accessible location.
Make sure that any empty slot in the BTS enclosure is filled in with a cover panel.