User's Manual

Fig 3-10: Net Element Management Screen

3.4 Base Station Startup

3.4.1 Base station normal startup

Base station power-on

For startup, the base station power, RF cables, calibration cable and GPS etc. must be

correctly connected. In particular make sure that the L3 network cable is connected. Also

the serial port cable of the base station can be connected to PC to update BTS IP

information or view startup message, etc. When everything is connected, switch on the

power, then switch on the main switch at the back of BTS and the base station will enter

startup.

Base station boot

The following is the content displayed and to be configured in HyperTerminal window

during base station startup.

bootrom booting!!!!!!!

VxWorks System Boot

CPU: 7447A Power PC

Version: VxWorks5.5.1

BSP version: 1.0/0

Creation date: Aug 4 2006, 13:44:28

Press any key to stop auto-boot...

Configuration of Parameters