User's Manual

20
Appendix B: Telnet Commands
Command Category R/W Default Usage Description
audioalign Admin RW 1800 secs set audioalign [duration_secs]
show audioalign
Set Audio Antenna Alignment duration in
seconds
Duration 0 disables the beeping.
date Admin RW date [-u]... [MMDDhhmmYYYY
Options:
-u Apply the UTC time zone offset to the
date
Display or set current date
default Admin W
default
Restores system to factory defaults
ftpaddr Admin RW 192.168.1.1 set ftpaddr [a.b.c.d] show ftpaddr Set remote ftp server IP address
ftppass Admin RW p set ftppass [password] show ftppass Set remote ftp server password
ftpuser Admin RW ftp set ftpuser [user] show ftpuser Set remote ftp server username
log Admin R show log Show Event Log
name Admin RW (blank) set name [name] show name Set system name
ntpaddr Admin RW 192.168.1.1 set ntpadd [a.b.c.d] show ntpaddr Set NTP server address
password Admin W admin password (prompts lead user for password change) Change admin password
ping Admin W ping [OPTION]... Host
Options:
-c CNT Send only CNT pings
-s SIZE Send SIZE data bytes in packets
(default=56)
-I iface/IP Use interface or IP address as source
-q Quiet, only displays output at start
and when finished
Test network connectivity
reboot Admin W
reboot
Reboot system
savecfg Admin W
savecfg
Save configuration to permanent memory
serialnum Admin R show serialnum Show system serial number
snmp Admin RW enabled
public – for all
strings
192.168.1.1 for trap
manager
set snmp enable=[yes|no]
set snmp [read-community|rc]=[abcdef]
set snmp [write-community|wc]=[abcdef]
set snmp [trap-community|tc]=[abcdef]
set snmp [trap-manager|tm]=[a.b.c.d]
show snmp
Set SNMP configuration parameters
status Admin R
status
Show system status
sysmode Admin RW PTP_SLAVE
show sysmode
set sysmode <PTP_MASTER | PTP_SLAVE>
Show / Set the PTP operating mode