User Manual

8. System Reboot
At times, you may want to reboot the unit for various reasons. This feature may
be convenient if the unit is mounted at a hard-to -reach location or when you
want to remotely reboot the unit without physically having to go to the site.
• Click on the Reboot menu option under the Advanced parent menu of the
left menu bar to access he following screen:
Click on the Reboot button to reset/reboot. The reboot process will take
approximately 30 seconds. Once the rebooting is done, you can use the Click
Here button below to access the user interface again.
Appendices
Appendix A
Factory Default Values
The following table details the factory default values. These are the values that
will be set initially at the factory or when you reset the configuration database.
WIRELESS
Radio Spectrum bandwidth normal
Channel 5805
Transmission Rate 36 Mbps
LAN
IP Address 192.168.0.1
Subnet Mask 255.255.255.0
Appendix B
Troubleshooting Guide
1. Can’t get a wireless connection with a client unit.
• Make sure that the client is added to the authorization list by typing in its
MAC address in the Add Station section.
• Make sure that the distance between the base and client units is within the
specified system range. A quick check of the signal strength and quality
indicators can help asses a marginal RF link. Poor indicator response may
be due to the following reasons:
- Your link distance has exceeded the unit’s capability: Review your
link budget to make sure that the system is able to handle the
distance. Use GPS devices to accurately determine the link distance
first. If you are unsure about the link budget, you may contact
Solectek Technical Support for help.
- Antenna misalignment: your antennas need to be aligned correctly
at each others bore site for you to get the best results in signal
strength.
- Radio interference: The radio activity in the environment is too
strong and may interfere with your signals. You may try to
determine the source by using a spectrum analyzer and a
directional antenna.