User Manual

C. CONFIGURING THE BASIC SKYWAY 5000 PROPERTIES
• Click the Configuration menu option in the left menu bar to access the
following screen:
• System name
This is a description of the unit for convenience. This is not related to
the identification of the unit on your local area network.
• IP properties (LAN)
- IP Address: This is the IP address of the unit.
- Subnet Mask: This is the subnet mask of the unit.
- Default Gateway: the default gateway of the unit.
If you change any of the parameters, click on the Update button to
make the changes effective. You can also restore the previous setting
by clicking on Reset button.
• Wireless properties
- Radio Spectrum Bandwidth: There are two choices here:
Normal (default setting) and Wideband. The following is the
table for available radio frequency and data rate for each
option
If you change the Radio Spectrum bandwidth value, be sure to
click the Select button just below.
NORMAL (20MHz)
Frequency (MHz) 5735, 5755,5775,5795, 5815,
5845
Data Rate (Mbps) 54, 48, 36, 24, 18, 12, 6
WIDEBAND (40MHz)
Frequency (MHz) 5745, 5785, 5825
Data Rate (Mbps) 108, 96, 72, 48, 36, 24, 12
- Radio Frequency (MHz): the center frequency of the
selected frequency channel. In the Normal mode, each channel
is 20 MHz wide. In the wideband mode, it is 40 MHz.
- Data Rate : air transmission/receive data rates. Note that
different data rates are available for normal and wideband
modes, as detailed in the table above.
If you have edited any of the fields, click on the Update button on the
bottom to write the changes into system memory. Clicking on the Clear
button restores the original values before the changes.