User's Manual

This document is Solectek CONFIDENTIAL and may not be reproduced without written permission. V1.5
fis create -b 0x800000 -l 0x20000 -f 0x505c0000 solconfig
• Power cycle the Minotaur board and verify successful reboot
• Via Serial Console, or Telnet access, set desired system configuration parameters, including
the Ethernet MAC address recorded earlier.
8. FCC Radio Frequency Interference Statement
FCC ID: KA358MRS1
This device is certified to comply with Part 15 of Federal Communications Commission (FCC) Rules. Operation is subject to the
following two conditions:
1. It may not cause harmful interference.
2. It must accept any interference that may cause undesired operation.
Changes or modifications not expressly approved by Solectek could void the user’s authority to operate the equipment.
U.S. Government Restricted Rights Legend
The Product is provided with Restricted Rights. Use, duplication, reproduction or disclosure by the Government is subject to
restrictions in subdivision (c)(1)(ii) of the Rights in Technical Data and Computer Product clause at 252.227-7013 and in
subparagraphs (a) through (d) of the Commercial Product-Restricted Rights Clause at 52.227-19. Contractor/Manufacturer is
Solectek, 6370 Nancy Ridge Drive, Suite 109, San Diego, California.
Radio Transmission Notice
This product is a low power (less than 1 Watt), OFDM radio system pre-set to transmit and receive signals in the 5.725 – 5.850
GHz frequency band. This product has been certified by the U.S. Federal Communications Commission for use in the United
States of America in that band. Other markings on the unit label shall indicate regulatory compliance in other international
areas.
Any prospective user of this product outside the United States of America should, prior to such use, contact the government
department or other agency responsible for assigning radio frequencies in the country in which use is proposed to determine
whether such department or agency has any objection to operation of the product given current regulatory label markings on
said product, and whether there are any other local devices generating signals in that band which might be expected to interfere
with the operation of this product.
Solectek shall not be responsible for any operation of this product which is in violation of local law, creates interference harmful
to other local devices, or results in a malfunction of this product caused by outside interference.
This device must be professionally installed and used in strict accordance with the manufacturer's instructions. However, there
is no guarantee that interference to radio communications will not occur in a particular commercial installation. In case the
device does cause harmful interference with an authorized radio service, the user/ operator shall promptly stop operating the
device until harmful interference has been limited. Solectek Corporation is not responsible for any radio or television interference
caused by unauthorized modification of this device or the substitution or attachment of connecting cables and equipment other
than specified by Solectek Corporation. The correction of interference caused by such unauthorized modification, substitution, or
attachment will be the responsibility of the user.
Warning:
The antennas used for this transmitter must be installed to provide a separation distance of at least 20 cm from all
persons and must not be co-located or operating in conjunction with any other antenna or transmitter
This equipment has been tested and found comply with the limits for a Class A digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated
in a commercial environment. This equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the
interference at his own expense.
Revision History
REV DATE ECO # AUTHOR DESCRIPTION
1.0 14-Sep-07 D. Gell original