User's Manual

This document is Solectek CONFIDENTIAL and may not be reproduced without written permission. V1.5

1. Introduction

For the Phase II release, the Configuration of the MRS boardset can be changed in three ways:

HTTP GUI, Telnet and Configuration File.

1. The GUI is functional, though per Solectek schedule, is not completely functional.

2. Telnet may be used to work with the commands listed in this document.

3. The Configuration File may be offloaded, modified and re-stored on the MRS.

2. Unit Power

The MRS boardset is intended to be powered via the 2pin, +48V connector on Minotaur. The Solectek

Base Station is to be powered via PoE, supplied by the included Power Supply/Injector and connected

into the RJ45 Minotaur connector

3. Unit Access

Both HTTP and Telnet access is password protected. Default access is as follows:

Password: Solectek

4. Unit Defaults

MRS Boardset Solectek Base Station

Network Mode Bridge Bridge

Ethernet IP Address 172.21.0.100/255.255.0.0 172.21.0.10/255.255.0.0

RF IP Address 192.168.1.x/255.255.255.0 192.168.1.x/255.255.255.0

RF Mode Client Access Point

SSID Koito_2 Koito_2

Encryption Open Open

RF Bandwidth 20 MHz 20 MHz

5. Telnet

Any Telnet client can be used to access the MRS and Base Station devices. Access is per

direct commands, or by (b) modifying the configuration file.

5.1. Direct Commands

set_config

The set_config can be used to change (or add) a configuration variable. On in the Telnet

shell, the command may be invoked as: