User's Guide
Table Of Contents
- SkyWay Wireless Bridge/Router
- Preface
- Table of Contents
- Chapter 1: Introducing Skyway
- Chapter 2: Getting to Know the SkyWay Bridge/Router
- Chapter 3: Preparing for Installation
- Chapter 4: Installing Skyway
- Chapter 5: Configuring and Managing SkyWay
- Configuring SkyWay
- Setting System Configuration Parameters
- Understanding RF-DLC
- Configuring the Ports
- Bridging
- IP Routing
- Internet Control Message Protocol
- SNMP
- Diagnostics
- File Transfer Utilities
- Security
- Chapter 6: Monitoring SkyWay
- Chapter 7: Troubleshooting Skyway
- Appendix A: Run-time Menu Tree
- Appendix B: BIOS Menu Tree Summary Table
- Appendix C: Interface Specifications and Pinouts
- Appendix D: Detailed Product Specifications
- Appendix E: Supported Protocols
- Appendix F: Error Codes
- Appendix G: SNMP Trap Messages
- Appendix H: Installation Recording Form
- Appendix I: Sources of SNMP Management Software
- Appendix J: Glossary and Basic Concepts
- Appendix K: Skyway Antennas
- Warning:
- Notes:
- 7002301: 6 dBi Omni Directional Antenna
- 7002401: 11 dBi Omni Directional Antenna
- 7002501: 16 dBi Outdoor Flat Panel Directional Antenna
- 7002601: 17 dBi Outdoor Flat Panel Directional Antenna
- 7002701: 22 dBi Outdoor High gain Flat Panel Directional Antenna
- 7002801: 8 dBi Indoor/Outdoor Patch Antenna
- 7002901: 12 dBi 110 Outdoor Sectorial Antenna
- Index
94
Forward Broadcasts [swIpBcastforwarding] •Enabled
• Disabled
Indicates whether IP broadcast messages are forwarded (Enabled) or not forwarded
(Disabled) if they are received.
IP Reassembly Timeout [swIpReasTimeout] 8
Determines how many seconds to wait before discarding a packet when all frag-
ments have not yet arrived.
Default Gateway Enabled [swDefaultGateway] •
••
•No
NoNo
No
•Yes
Set to Yes to set a default gateway.
Default Gateway IP
Address
[swDefaultGatewayI-
PAddr]
Enter the IP address to send IP datagrams for which no route was found
Default Gateway Port
Number
[swDefaultGatewayInter-
face]
The SkyWay port number to use when forwarding IP datagrams with unknown
routes.
Field Name MIB
Settings (default in
bold)