User's Guide
Table Of Contents
- SkyWay Wireless Bridge/Router
- Preface
- Table of Contents
- Chapter 1: Introducing Skyway
- Chapter 2: Getting to Know the SkyWay Bridge/Router
- Chapter 3: Preparing for Installation
- Chapter 4: Installing Skyway
- Chapter 5: Configuring and Managing SkyWay
- Configuring SkyWay
- Setting System Configuration Parameters
- Understanding RF-DLC
- Configuring the Ports
- Bridging
- IP Routing
- Internet Control Message Protocol
- SNMP
- Diagnostics
- File Transfer Utilities
- Security
- Chapter 6: Monitoring SkyWay
- Chapter 7: Troubleshooting Skyway
- Appendix A: Run-time Menu Tree
- Appendix B: BIOS Menu Tree Summary Table
- Appendix C: Interface Specifications and Pinouts
- Appendix D: Detailed Product Specifications
- Appendix E: Supported Protocols
- Appendix F: Error Codes
- Appendix G: SNMP Trap Messages
- Appendix H: Installation Recording Form
- Appendix I: Sources of SNMP Management Software
- Appendix J: Glossary and Basic Concepts
- Appendix K: Skyway Antennas
- Warning:
- Notes:
- 7002301: 6 dBi Omni Directional Antenna
- 7002401: 11 dBi Omni Directional Antenna
- 7002501: 16 dBi Outdoor Flat Panel Directional Antenna
- 7002601: 17 dBi Outdoor Flat Panel Directional Antenna
- 7002701: 22 dBi Outdoor High gain Flat Panel Directional Antenna
- 7002801: 8 dBi Indoor/Outdoor Patch Antenna
- 7002901: 12 dBi 110 Outdoor Sectorial Antenna
- Index

viii
After inspecting the failed unit, Solectek will repair or replace materially defective parts
or components. All products that are replaced become the property of Solectek. If
upon inspection by Solectek, a unit returned under warranty is deemed to be damaged
or out of warranty for any reason, (see LIMITATIONS section below), Solectek will
contact the customer with a price for the repair or replacement unit. Upon receipt of
payment (wire transfer, certified check, credit card, etc.) for the replacement unit plus
outbound shipping fees, Solectek will send a repaired or replacement unit to the cus-
tomer. Customers who do not accept the repair offer may receive their failed equip-
ment back by prepaying an inspection fee of $300 and the return freight cost.
If upon inspection by Solectek, a unit returned under warranty is found to be defect
free, Solectek reserves the right to charge the customer a $500 test fee.
SOLECTEK’S SOLE AND EXCLUSIVE OBLIGATION, AND YOUR SOLE AND
EXCLUSIVE REMEDY, UNDER THIS LIMITED WARRANTY SHALL BE THE REPAIR
OR REPLACEMENT OF THE APPLICABLE SOLECTEK PRODUCT IN ACCOR-
DANCE WITH THE TERMS SET FORTH HEREIN.
LIMITATIONS
As the original purchaser, you receive these warranties from Solectek Corporation,
subject to the terms and limitations set forth below.
Solectek warrants that your Solectek products will be free from defects in material and
workmanship and will perform in substantial compliance with the operator’s guide(s)
accompanying Solectek products. Warranty is given for twelve (12) months from the
date of product shipment from Solectek for new hardware products and ninety (90)
days for spare parts and R- part numbers. Solectek will honor this warranty upon
receiving proof of purchase. “Proof of purchase” is a copy of the original sales transac-
tion, showing complete name and address of seller, complete name and address of
purchaser, date of purchase, model number, and serial number.
Solectek does not cover or accept liability for any injury, damage or failure caused by
misuse, misapplication, abuse, acts of nature, accidents (e.g., dropping the Solectek
products or software diskettes), electrical mishaps, causes beyond our control, or
claims by other than the original purchaser.
Solectek will not honor, and will consider this limited warranty voided, if, in Solectek’s
reasonable judgment, there has been any (1) tampering with the Solectek product’s
external label or serial number, (2) attempt to open the Solectek product’s case with-
out prior written consent from Solectek, (3) attempted or actual repair by anyone
other than an authorized Solectek technician, (4) installation or use with any power
supply component(s) other than the original Solectek power supply components pro-
vided in the product package, (5) for installations within the U.S., installation or use
with any cables or antenna(s) other than original Solectek products, (6) installation or
use in environmental conditions that are outside Solectek’s published environmental
specifications (including but not limited to temperature range, humidity, cable lengths,
proximity to other devices, etc.).
This warranty is available only to the initial end user purchaser of the product and is not
transferable. This warranty is applicable only to products purchased using Solectek’s