User's Guide

Table Of Contents

Mounting to a Wall

The wall mount kit is optional and may be purchased separately.

To o l s :

To o l s :To o l s :

To o l s :

• 13 mm wrench

1. Place the SkyWay face down.

2. Align the two brackets over the SkyWay unit’s bolt holes, either along the length or

width of the unit.

3. Insert bolts and tighten with a 13 mm wrench.

Note: The bolts can be found in the Mast Kit, which is always shipped with SkyWay.

4. Fasten the SkyWay to the wall using the slider slots and bolts (not supplied), making

sure the SkyWay’s connectors face downward.

CAUTION: The surface to which you mount the Skyway and/or antenna should be

grounded. If the surface is not grounded, see “Grounding Skyway and the Antenna” on

page 47.

P/N 1225101

P/N 1225101P/N 1225101

P/N 1225101

www.solectek.com

Connector side down

Connector side downConnector side down

Connector side down