User's Guide

Mounting the SkyWay Unit
43
6. Position the bracketed SkyWay against the mast with the connectors facing down-
ward.
Note: The mast should be a minimum of 1 in. (25.4 mm) outside diameter.
7. Feed the end of each clamp around the mast into the locking mechanism at the
other end. Using a slotted screwdriver or nut driver, tighten the clamp screws to a
maximum torque of 45 ± 5 in-lbs.
CAUTION: The mast to which you mount the Skyway and/or antenna should be
grounded. If the mast is not grounded, see “Grounding Skyway and the Antenna” on
page 47.
Connector side down
Connector side downConnector side down
Connector side down