User's Guide
Table Of Contents
- SkyWay Wireless Bridge/Router User's Guide
- Table of Contents
- Chapter 1: Introducing Skyway
- Chapter 2: Getting to Know the SkyWay Bridge/Router
- Chapter 3: Preparing for Installation
- Chapter 4: Installing Skyway
- Chapter 5: Configuring and Managing SkyWay
- Configuring SkyWay
- Setting System Configuration Parameters
- Understanding RF-DLC
- Configuring the Ports
- Bridging
- IP Routing
- Internet Control Message Protocol
- SNMP
- Diagnostics
- File Transfer Utilities
- Security
- Chapter 6: Monitoring SkyWay
- Chapter 7: Troubleshooting Skyway
- Appendix A: Run-time Menu Tree
- Appendix B: BIOS Menu Tree Summary Table
- Appendix C: Interface Specifications and Pinouts
- Appendix D: Detailed Product Specifications
- Appendix E: Supported Protocols
- Appendix F: Error Codes
- Appendix G: SNMP Trap Messages
- Appendix H: Installation Recording Form
- Appendix I: Sources of SNMP Management Software
- Appendix J: Glossary and Basic Concepts
- Appendix K: Skyway Antennas
- Note:
- Note:
- Note:
- 7002301: 6 dBi Omni Directional Antenna
- 7002401: 11 dBi Omni Directional Antenna
- 7002501: 16 dBi Outdoor Flat Panel Directional Antenna
- 7002601: 17 dBi Outdoor Flat Panel Directional Antenna
- 7002701: 22 dBi Outdoor High gain Flat Panel Directional Antenna
- 7002801: 8 dBi Indoor/Outdoor Patch Antenna
- 7002901: 12 dBi 110 ˚ Outdoor Sectorial Antenna
- Index
IP Routing
99
Obtaining a Configuration Summary
Use screen 1.5 Configuration Summary to check system, port, bridging, routing, and
RF port configuration settings.
Field Name MIB
Settings (default in
bold)
Relaying [swBootpCfgRelayAgen-
tEnabled]
•Enabled
•
••
• Disabled
DisabledDisabled
Disabled
Set this field to Enabled to enable BOOTP functionality.
Destination Address [swBootpCfgRelayAgent-
ForwardIpAddr]
255.255.255.255
This is the server’s IP address. The default is the limited broadcast address.
Maximum Hops [swBootpCfgRelayAgent-
MaxHops]
4
This field sets the maximum number of times a BOOTP request can be routed. The
range is 1 - 16.
Broadcast Reply [swBootpCfgRelayAgent-
BroadcastReplyFlg]
•
••
•No
NoNo
No
•Yes
This field, if set to yes, forces all relayed BOOTP replies to be returned to the client
using the limited broadcast IP address.