User's Guide

90
1.3.1 Bridge Configuration
Use this screen to set global bridging parameters, disable bridging, or enable the Span-
ning Tree function.
Note The SkyWay does not support Port Priority [dotIdStpPortPriority] as defined in
RFC1493.
The following table lists the field name, the MIB name, and the default setting:
1.3.1. Bridge Configuration
Bridging : Enabled
Forwarding Table Timeout : 300
Spanning Tree : Enabled
Bridge Priority : 16961
Bridge Max Age : 20
Bridge Hello Timeout : 2
Bridge Forward Delay : 15
Multicast Address : 01:80:c2:00:00:00
\ -return to menu . - commands TAB - next available field ENTER - edit
Field Name MIB
Settings (default in
bold)
Bridging [swBridgeEnable] •
••
•Enabled
EnabledEnabled
Enabled
• Disabled
Enables or disables bridging on the system. If you disable bridging on this screen, it is
disabled for all ports. If you change this parameter, you must reset the unit. Bridging
supersedes spanning tree function, that is, if you disable bridging, spanning tree is
also disabled.
Fowarding Table Timeout [dotldTpAgingTime] 300
The timeout period in seconds for aging out dynamically learned forwarding infor-
mation.
Spanning Tree [swBridgeSTPEnable] • Enabled
•
••
• Disabled
DisabledDisabled
Disabled
Enables or disables spanning tree function.